Ran into an issue with a user where I needed to remotely access their computer. They needed software installed ASAP and of course did not have admin access to the computer. I had them go to www.teamviewer.com and install the light client which does not require administrative access.
When going to install the application UAC came up but I could not see, click, or type when UAC was active. With some quick googleing I was able to find that you can run the client with administrative credentials upon connecting to the client. PROPS Teamviewer.
See the steps below.
| 1. |
Fire up Teamviewer |
|
|---|---|---|
| 2. |
Ask for the ID number for the user, connect to that ID.This will be a 9 digit number |
|
| 3. |
Local admin already?If the user is not local admin already (if they are you will be able to interact with UAC), you will be prompted with this screen |
 |
| 4. |
Click on ‘Click for additional information’You will be prompted with the next window |
 |
| 5. |
Authenticate as the local admin accountThis basically allows you to restart the clients Teamviewer session with the local administrator account |
 |
| 6. |
Connect & interact with UAC on a standard account!Once you enter correct credentials, the status in the bottom left will tell you that it is restarting, and then you will join the end user’s session, as always |
 |
Recent Comments